AI Builder
Describe what you want to build in your own words. The AI plans the project, you review the plan, and only then does it build.
Before you start
- You need a free account. The AI Builder is included on every plan.
- It works on a laptop or desktop, in the editor at app.arduinostudio.com.
- You can also type your idea in the box on the home page or pick one from project ideas. After you sign in, the editor opens with your idea already filled in.
Start a new project
- Create a new project. An empty project opens on Describe your project.
- Type what it should do, for example “a button that toggles a red LED, with a slider for brightness”, or tap one of the example ideas under the box to fill it in. Tapping only fills the box; nothing is sent until you press the button.
- Read the plan. Review this plan lists the new logic blocks with their settings, changes to existing blocks, new controls for the App stage, and what happens after applying. Nothing changes until you apply.
- Click Apply changes, or Discard to leave the project as it was.
After applying, the blocks are on the canvas, any controls are in stage 3 App, and the wiring diagram in stage 2 Wiring follows from the new blocks. A project built from scratch can also get a name and a README describing it. A new build runs once in the preview by itself; if you had moved to another stage meanwhile, a note tells you it is built and asks you to open Logic and press Play.
Watch how (2 min): Build and edit with the AIWatch (1 min): Ask for an ESP32 project with a phone app
Change an existing project
Click AI Builder beside the canvas (or in the editor toolbar) to open it next to your project, then ask for a change: “make the LED dimmer”, “add a buzzer that beeps when the button is pressed”. You review every change the same way before it’s applied.
Keep talking
The AI Builder is a conversation. While a plan is waiting for review, type a reply to change it, for example “use pin 4” or “make it 200 ms”, and you get a new plan in its place. After applying, ask for the next change; the AI remembers what you said earlier, so “make it blink faster” means the LED you just added. Typing “yes” never applies anything: only the Apply button does.
- Undo on the latest applied change (or Ctrl+Z on the canvas) puts the whole change back in one step. If you edited the project since, it tells you to step back on the canvas instead, so your later work is never lost.
- The conversation stays on this device for 30 days, per project. New conversation starts over without touching the project, and signing out clears it.
Good to know
- It builds with the same blocks you can add yourself, so the result has the same limits. Check the components page for where each block runs.
- You can send up to 6 requests a minute.
- When the AI engine answering you is busy, the AI Builder switches to another one and keeps working. Only when every engine is busy do you see “The AI is busy right now, try again in a minute. Your project has not changed.” Send the same request again after a minute.
- Requests that contain an email address, phone number, password or other private details are refused. Describe the project, not the people.
- It can get things wrong. That’s what the review step is for, and every block stays editable afterwards.
Next steps
- Press Play to run the project in the simulator, or connect a board: Getting Started.
- Read the Arduino code the AI’s blocks make in Dev mode.
- Build the circuit with the Wiring view.
Build a smart room on an ESP32 in the live demo, in the preview with no board, account or install: open the demo